My PNG image shows transparent in some areas in my sketchup model, but when I open Enscape the whole image becomes solid again and the previous transparent areas are now black. What should I do?
Rendering PNG from sketchup to enscape
- Renchoate
- Thread is Unresolved
Whenever you encounter any issues with Enscape or your subscription please reach out to our dedicated support team directly through the Help Center or by using the Feedback button as detailed here.
-
-
Demian Gutberlet
Approved the thread. -
Renchoate , welcome to our Forum.
Could you kindly make sure that the material is also set up correctly in/through our dedicated Material Editor? (click to get to our dedicated knowledge base article)
If you've already checked, please also send me a screenshot of the material settings at hand so I can have a look myself to see where the issue may be.
-
I was able to resolve this by making the material a foliage. Thanks! Demian Gutberlet
-
maybe it was on the back side.. I noticed that when You have a png texture on both sides but they are not aligned the front side will look correct but the back side's transparent areas will be obstructed by front side.. same with any transparent material.. If You have a glass on front side and brick on back side then glass looks correct.. If You put glass on the back and brick on front then from back side You will see a brick shining through your glass. I thought it is known issue.. Some renders don't care much about front and backsides.. some do.. in general better to keep it consistent..