View with exe file

  • When you open the exe file on any pc, the first camera view is on "fly" mode, then you press "walk" mode (on the screen or press tab in the keyboard ) and can start your tour, fine,


    Although sometimes when you open the exe file and try the "walk" mode the camera view goes outside your building (either high or low) and it is difficult to get it back in default position. I am talking about costumers or people who want to see your project in their own pc and suddenly cannot go back to default camera high/position.


    Is there any way to make the "walk" mode more user friendly for people who have trouble understanding the principles of using the keyboard & the mouse at the same time?.


    Is is possible to avoid to jump out of the building after getting the "walk" mode?


    Regards

  • Hey LOLserver , thanks a lot for your post.


    So generally, the jumping outside the building is caused by ceilings being a bit too low for example, sometimes if you're also in a wall, or halfway in a ceiling / floor for example and switch from flymode to walkmode, this behavior can occur sometimes. Perhaps you can make sure that you're located well in a room where the "viewer/player" is not touching any walls/ceilings.


    Furthermore:

    Is there any way to make the "walk" mode more user friendly for people who have trouble understanding the principles of using the keyboard & the mouse at the same time?.

    In this case what I can definitely recommend is a dedicated Xbox (One/360) controller. Maybe this is what you're looking for. :)