I'm Korean. Only library files cannot be rendered.

lo369zx , welcome to our forum!

Don't worry about the translation, I get the problem - in the first instance, can you please make sure that your Units in Rhino are set to centimetre:

That should already help. If it does not, please let me know!

Quote from lo369zx

That GPU and CPU is well supported by Enscape, no worries.

Can you in this case please check where this Asset is located? If it is not located on the "Default" layer, can you make sure that is the case? Perhaps it is already placed there but the layer is turned off?

Thank you again in advance, if that doesn't explain it, please send in a feedback report. Before that, you can also try our latest release which just came out yesterday.

lo369zx , sorry for the delayed response - is there any chance you actually please also send in a feedback report:

https://enscape3d.com/communit…sing-the-feedback-button/

That could actually be rather helpful - also, just to make sure, please uninstall Enscape, then reboot the machine, run the Enscape installer again and in the first window of the installation process, where you will see the checkbox named 'I accept the terms in the License Agreement' make sure that is checked. This will enable the Advanced button which you should then click to proceed to the next window which will offer you the option to install for all users of the machine.

But, the feedback report would be rather important to have.