Posts by Rkitekt01

Reminder: If you encounter any issues with Enscape (including installation problems) or your subscription please reach out to our dedicated support team directly through the Help Center or by using the Support button as detailed here. Thank you for your understanding.


    I'm running with dual 1080 Ti's so the speed of the cards isn't the issue on this one. Previous versions of Enscape have run pretty well. It's only been the last few updates that have caused various glitches and speed issues.

    Has anyone else run into any speed issues with the new update?


    Hey Guys,

    I posted another topic about the VR glass that still hasn't been resolved. Today I'm running into another issue completely. I updated Enscape this morning (9/7) and now whenever I load the program it throttles my computer to the point where the keyboard can't even keep up. I'm currently trying to render a basic panorama and my computer is running abysmally slower than normal. I can operate in SketchUp, Revit, and Lumion without any issues.

    However for some reason while having Enscape open and running, the program runs so much slower than it used to. I had the settings set to the same caliber as previous verison on larger files and now it goes to 1 frame per sec while trying to navigate. I'm running it in a 9 MB sketchup file. Sure three's a good amount of 3d points but this file doesn't give me trouble any other time. I will keep digging to make sure it's enscape causing the issues but I was going to check and see if anyone else has had these issues?




    I reset the tabs and it's still glitchy. I set the render quality to Ultra and it's worse. I set it to Low and the glitches still occur but they're black instead of white (on Ultra).

    It appears to be only on the glass. Our glass components are full boxes. Do they need to be single planes? Do I need to uninstall Enscape completely and reinstall it?


    Hey Thomas,

    I'm using dual 1080 Ti's but SLI is disabled because I'm running them to separate monitors. I haven't tried the preview version. I updated all my drivers so it's possible there's something that's conflicting between them now. I haven't really messed with the settings too much.

    It did this to me a long time ago and then Enscape updated and it went away. So it's possible I'm not actually running the most up to date version. Let me double check on that and get back to you.

    Hello Everyone,

    I've had an Enscape license for a while but couldn't get anyone on board at work. Now that they've found merit in it they want to pursue it. I haven't booted it up in a while, but the software is up to date according to the infe window. However, when switching to VR the quality gets so bad that there's no feasible way to use it for client presentations. The glass glitches really badly and flashes repeatedly.

    Does anyone have any ideas? I'm running SketchUp 2018, the most recent Enscape, with an Oculus Dk2. Here's a screenshot of what I'm running into. According to my computer all my drivers are up to date but Ill double check.

    Thanks for any help you can give me,