Posts by massimo_risca

Sorry if I forgot to answer, yes you have been very helpful, thank you very much!

Hi, thanks Jtubb.
I used your method but I also slightly changed other parameters of the material, which in my case is also printed.
The result is this.
I hope a similar material will be developed, because I am not 100% satisfied with the result, especially with the refraction of the grooves.

Thanks for solving the problem.
In order to make you work on real issue: I had already deactivated the license in the PC in my office.
Is it possible that issue it was dependent on the change of SSD in which the operating system resides?
In any case, I invite you to set up a response system from the support even on weekends, because if a customer has an urgency he can be helped.
Thanks

Please has anyone ever reproduced the polycarbonate like the one in the picture? How did you set up the material?

I think your software is done very well, but the support you provide is definitely not adequate for professional use. From Friday at 5pm I requested support for a stupid licensing problem (error 64) that has already occurred. I have to produce urgent renders that I have not been able to do, with serious damage to my work. If you are unable to offer support in a short time you should report it on the site at the time of purchase. I think I will have to consider other products.

Hello, please I need support to reset my license.
I send messages at support@, private messages and also used "feedback" but but nobody answered.
I need quick support to complete an urgent project.
This is not the first time this license issue has occurred.
Please find a solution.
Thanks